Toro 74942 - Adjusting the Motion-Control Damper; Adjusting the Motion-Control Neutral-Lock Pivot

6.Runtheunitatleast5minuteswiththedriveleversat
fullforwardspeedtobringhydraulicoiluptooperating
temperature.
Note:Themotion-controlleverneedstobeinneutral
whilemakinganynecessaryadjustments.
7.Bringthemotion-controlleversintotheneutral
position.Adjustpumpcontrolrodlengthsbyrotating
thedoublenutsontherodintheappropriatedirection
untilthewheelsslightlycreepinreverse(Figure84).
Movethemotion-controlleverstothereverseposition
andwhileapplyingslightpressuretotheleverallow
thereverseindicatorspringstobringtheleversback
toneutral.Thewheelsmuststopturningorslightly
creepinreverse.
g027409
Figure84
1.Doublenuts
8.Shutoffunit.Removejumperwirefromwireharness
andplugconnectorintoseatswitch.
9.Removethejackstands.
10.Raisethedeckandre-installtheheightofcutpin.
11.Checkthatthemachinedoesnotcreepinneutralwith
theparkbrakesdisengaged.
AdjustingtheMotion-Control
Damper
Thetopdampermountingboltcanbeadjustedtoobtaina
moredesiredmotion-controlleverresistance.SeeFigure85
formountingoptions.
Figure85
RHMotionControlShown
1.Torquethelocknutto22.6N-m(16.7ft-lb).Boltmust
protrudepastendoflocknutaftertorque.
2.Mostresistance(rmestfeel)
3.Damper
4.Mediumresistance(mediumfeel)
5.Leastresistance(softestfeel)
AdjustingtheMotion-Control
Neutral-LockPivot
Theangednutcanbeadjustedtoobtainamoredesired
motion-controlleverresistancewhenmovingittothe
neutral-lockposition.SeeFigure86foradjustmentoptions.
1.Loosenthejamnut.
2.Tightenorloosentheangednuttothedesiredfeel.
Formoreresistance,tightentheangednut.
Forlessresistance,loosentheangednut
3.Tightenjamnut.
Figure86
1.Flangednut2.Jamnut
53