Toro 74991 Z Master Professional 5000 Series - Mower Deck Maintenance

G008968
1
2
Figure92
Bottomviewofthemachine
1.Filterlocations
2.Hydrauliclter
6.Applyathincoatofhydraulicuidtotherubbergasket
onthereplacementlter(Figure92).
7.Installthereplacementhydrauliclter.
8.Installthepump-drivebeltandthemowerbelt.
9.Removethejackstandsandlowerthemachine(Figure
91).
10.Adduidtothehydraulicreservoirandcheckforany
leaks.
11.Cleanupanyspilleduid.
12.Starttheengineandletitrunforabout2minutesto
purgeairfromthesystem.
13.Shutofftheengineandcheckforleaks.
14.Checktheuidlevelwhiletheoiliscold.
15.Ifrequired,adduidtothehydraulicreservoir.
Note:Donotoverll.
MowerDeck
Maintenance
LevelingtheMowerDeck
SettingUptheMachine
Note:Ensurethatthemowerdeckislevelbeforematching
theheightofcut(HOC).
1.Positionthemoweronaatsurface.
2.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition,
andsettheparkingbrake.
3.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
4.Checkthepressureofthedrivetires.
Note:Properinationpressureforthetiresis90kPa
(13psi).
5.Positionthemowerdecktothe76mm(3inch)
height-of-cutposition.
LevelingtheDeck
1.Positionthemoweronaatsurface.
2.Shutofftheengine,waitforallmovingpartstostop,
removethekey,andengagetheparkingbrake.
3.Checkthepressureinthedrivetires.
Note:Properinationpressureforthetiresis90kPa
(13psi).
4.Positionthetransportlockinthelatchingposition.
5.Pushthedeckliftpedalallthewayforwardandthe
deckwilllatchatthe14cm(5-1/2inch)transport
position(Figure93).
Figure93
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
60