Toro 74991 Z Master Professional 5000 Series - Page 61

6.Inserttheheight-adjustmentpinintothe7.6cm(3
inch)height-of-cutlocation.
7.Releasethetransportlockandallowthedecktolower
tothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA)as
showninFigure94.
Note:Themeasurementshouldread7.6mm(3
inches)
Figure94
1.7.6cm(3inches)at
positionAiscorrect.
3.Measureherefromthe
bladetiptothehard
surface.
2.8.3cm(3-1/4inches)at
positionBiscorrect.
4.MeasureatpositionAand
Bonbothsides.
10.Ifneeded,loosentheangedlocknutonthesideofthe
yokeandthejamnutontop.
11.Fine-tunetheadjusterscrewbyturningittoget7.6
mm(3inch)height(Figure95).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
g029650
1
2
3 4
12
Figure95
1.Flangedlocknut3.Jamnut
2.Adjusterscrew4.Yoke
12.Ifthefrontdecklinksdonothaveenoughadjustment
toachieveaccuratecutheight,loosenthe2boltsat
thebottomoftheheight-of-cutplatetoadjustthe
single-pointsystem(Figure96).
g029651
1
Figure96
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow ,tightenthesingle-point
adjustmentboltbyrotatingitclockwise.Ifthedeckis
toohigh,loosenthesingle-pointadjustmentboltby
rotatingitcounterclockwise(Figure97).
Note:Loosenortightenthesingle-pointadjustment
boltenoughtomovetheheight-of-cutplatemounting
boltsatleast1/3thelengthoftheavailabletravelin
theirslots.Thisregainssomeup-and-downadjustment
oneachofthe4decklinks.
61