Toro DDC Series - Programming Sequence Diagram

* As you press the "Prog." button, the dial
will jump back to the "Run Time" position.
Block Diagram presentation of the programming sequence of
the 3 irrigation parameters: Run Time, Days and Starts for each
program.
-5-
Run Time
Prog. A
DAYS
Prog. A
Starts
Prog. A
Run Time
Prog. B
DAYS
Prog. B
Starts
Prog. B
Run Time
Prog. C
DAYS
Prog. C
Starts
Prog. C
% Scaling
Prog. A