What to do if my Toro Lawn Mower starter does not crank?
If the starter on your Toro Lawn Mower isn't cranking, first ensure the blade control (PTO) knob is in the Disengaged position and that the parking brake is set. Then, check the battery charge and the electrical connections for good contact. Replacing the fuse may also resolve the issue.
Why don't the blades rotate on my Toro Lawn tractor?
If the blades on your Toro Lawn tractor do not rotate, install a new blade drive belt if the current one is worn, loose, or broken. If the blade drive belt is off the pulley, install it and adjust it for the correct tension. Ensure the grass collector is properly installed.
How to fix uneven cutting height on a Toro Lawn tractor?
If the cutting height is uneven on your Toro Lawn tractor, start by setting the tire pressure correctly. Then, adjust the height adjustment cable rod assembly to ensure the mower is level. Clean the underside of the mower if it's dirty. Check the blade mounting screws and tighten them if they are loose. Finally, adjust the blade drive belt if the tension is incorrect.
Why does my Toro DH 210 Lawn Mower engine not start?
Several factors could prevent your Toro Lawn Mower engine from starting. Ensure you are sitting on the seat and that the fuel tank is adequately filled. Other potential solutions include cleaning or replacing the air cleaner element, properly installing the wire on the spark plug, installing a new, correctly-gapped spark plug, adjusting the throttle cable, replacing the fuel filter, and opening the fuel shut-off valve.
What to do if my Toro Lawn tractor engine will not start?
If your Toro Lawn tractor's engine won't start, starts hard, or fails to keep running, make sure you are sitting on the seat. Also, check if the fuel tank is empty and fill it with gasoline if needed. Other potential causes include a dirty air cleaner (clean or replace it), a loose or disconnected spark plug wire (install it), a faulty spark plug (install a new, correctly-gapped one), a choke that is not closing (adjust the throttle cable), dirt in the fuel filter (replace it), an incorrect idle speed or mixture (adjust the carburetor), a closed fuel shut-off valve (open it). If there is dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
How to fix an uneven cutting height on my Toro DH 210?
If your Toro Lawn Mower's cutting height is uneven, ensure the tire pressure is correct. Adjust the height adjustment cable rod assembly to level the mower. Clean the underside of the mower deck. Tighten the blade mounting screws.
How to fix a Toro DH 210 engine that loses power?
If your Toro Lawn Mower engine loses power, start by reducing your ground speed, as the engine load may be too high. Check the air cleaner element and clean it if it's dirty. Ensure the oil level in the crankcase is adequate; add oil if it's low. Also, inspect the cooling fins and air passages under the engine blower housing, removing any obstructions. Replace the spark plug if it's damaged or incorrectly gapped. Clean or replace the fuel cap to ensure the vent hole isn't blocked. Finally, replace the fuel filter if it's clogged with dirt.
Why is my Toro DH 210 Lawn Mower engine overheating?
If your Toro Lawn Mower engine is overheating, try reducing the ground speed, as the engine load may be excessive. Check the oil level in the crankcase and add engine oil if it's low. Also, inspect the cooling fins and air passages under the engine blower housing for any obstructions and remove them.
What to do if the blades on my Toro DH 210 Lawn Mower do not rotate?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken blade drive belt (install a new one), the blade drive belt being off the pulley (reinstall and adjust the tension), or the grass collector not being in place (install it).
Why is my Toro Lawn Mower engine losing power?
Your Toro Lawn Mower's engine may lose power due to several factors. Check if the engine load is excessive (reduce ground speed), the air cleaner is dirty (clean it), the oil level in the crankcase is low (add oil), the cooling fins and air passages are plugged (remove obstructions), the spark plug is faulty (replace it), the vent hole in the fuel cap is plugged (clean or replace the cap), or the fuel filter is dirty (replace it). If none of these resolve the issue, contact an Authorized Service Dealer.
General| Brand | Toro |
|---|---|
| Model | DH 210 |
| Category | Lawn Mower |
| Language | English |
Guidelines for safe operation of riding lawn mowers.
Pre-operation checks, fuel handling, and operator training.
Safe operating procedures and slope considerations.
Safe practices for maintenance and storage.
Toro product safety and sound level information.
Vibration levels and slope operation guidelines.
Explanation of safety and instructional decals on the machine.
Identifies and describes the machine's controls.
Lists the physical specifications of the machine.
Instructions for safely adding fuel to the machine.
Using fuel stabilizer and filling the tank.
Checking oil, using parking brake, seat, and headlights.
Using blade control, setting cutting height, and gauge wheels.
Procedures for starting and stopping the engine safely.
Understanding and using the safety interlock features.
Enabling and using reverse operation with KeyChoice.
Procedures to test the safety interlock system.
Pushing the machine manually and forward/backward driving.
Operating the traction control and reverse pedals.
Stopping the machine, using bag on demand, emptying collector.
Information on towing attachments and weight limits.
Tips for best performance, cutting quality, and maintenance.
Recommended maintenance tasks by service interval.
Greasing and lubricating the machine.
Servicing the air cleaner foam and paper elements.
Checking and changing engine oil.
Changing the oil filter and servicing the spark plug.
Draining the fuel tank and related safety.
Replacing the fuel filter and servicing headlights.
Replacing fuses and servicing the battery.
Procedures for removing and installing the battery.
Checking the battery electrolyte level.
Adding water to the battery and charging procedures.
Checking tire pressure and servicing the brake.
Removing, installing, and cleaning the grass collector.
Inspecting, sharpening, and removing/installing blades.
Steps to remove and install the mower deck assembly.
Procedure for adjusting the height adjustment cable rod.
Steps for preparing the machine for storage.
Lists common issues and their corrective actions.
Details warranty coverage, conditions, and service instructions.
To Next Page
