Toro GrandStand 74504TE - Lubrication; Greasing the Machine; Greasing the Torsion Idler

TORO®- Grandstand Service Instruction Manual3-12
3
CHASIS
Platform Removal (Figure 10)
1. Loosen the knobs on the tower.
2. Lower the cushion.
3. Remove the 4 bolts securing the fuel tank bracket.
4. Remove the fuel and vent lines from the top of the
fuel tank.
5. Remove the fuel tank.
6. Remove the 2 mounting bolts from the bottom of the
tower.
7. Remove the platform and cushion assembly from
machine, may need assistance.
8. Remove the hinge pad from platform.
9. Remove the rubber mat from platform by removing
the shield clamp.
10. Remove the link arms from platform.
11. Remove the ball knob assembly from platform.
Platform Installation (Figure 10)
1. Secure the 4 rubber bumpers to the frame using 4
nuts. Larger bumpers to outside of the machine.
2. Position the spring on the latch pin.
3. Position the latch pin and spring assembly into the
platform.
4. Apply thread-locking compound to the threads of the
knob.
5. Install the knob onto the latch pin. Torque to 40 +/-
10 in. lbs.
6. Position the carriage bolt through the platform, add
friction washer, spacer, pad link, flat washer and
lock nut. Torque to 105 +/- in. lbs.
8. Repeat steps for opposite side.
10. Place 4 screws with flat washers through hinge
pad and secure cushion to hinge pad. Torque to
100 +/- 20 in. lbs.
11. Place 2 thread forming screws outside of the shield
clamp, align tabs with holes in rubber mat and
secure to platform. Torque to 200 +/- 25 in. lbs.
12. Place the carriage screw outside of the link
through lock washer, spacer, and bottom hinge
pad hole (Figure 11). Add flat washer, tighten the
lock nut.
Figure 11