TORO®- Grandstand Service Instruction Manual 3-15
CHASIS
3
Deck Lift Assembly Removal
(Figure 12)
1. Lower the deck to the lowest cutting position.
2. Lower the cushion.
3. Remove the 4 bolts holding the fuel tank bracket.
4. Remove the fuel tank.
5. Lift up the engine guard to access the deck belts
(Figure 13).
6. Remove the deck belt from the PTO clutch.
7. Remove the 2 bolts holding the lift link to the deck.
8. Remove the deck from the machine by removing the
4 bolts that hold the deck to the deck hangers.
NOTE: Recommend placing 2, 2x4’s underneath
the deck to prevent damage and move to
side for ease of removal.
9. Remove the tap bolt from the extension spring.
(There will be no tension in the deck lift assembly).
10. Remove bolt holding the height of cut link
assembly to the lift arm.
11. Remove the 4 bolts holding the 2 black lift links.
12. Remove the 4 carriage bolts holding the 2 support
cross shafts.
13. Remove the snap retaining ring from left and right
hand lift arm. Remove the lift arms.
14. Remove the bolt holding the height of cut link from
the height of cut assembly.
15. Remove yokes, flat links, link chains from the rear
lift arms and front cross shaft.
16. Loosen all yokes and flat links to help with the
deck leveling after installation.
Figure 13
To Next Page
Loading...
