TORO®- Grandstand Service Instruction Manual
2
Specifications
2-2
Fuel System
Fuel Capacity 10. 6 Gallons
Fuel Shut-Off Valve In line between fuel lter and fuel tank
Fuel Tank Blow-molded .080 in. wall
Fuel Gauge N/A-Natural tank color.
Mounting Located inside the tower and constrained by bolt-on bracket.
Construction
Engine Base 1/4 in. (.250) thick 50 ksi.
Carrier Frame 3 x 1.5 x 11 gauge (0.130 in.) wall tube welded to 7 GA 0.1793 in., side plates
with 0.3125 in. mounting plates. Frame includes deck lift mounts, battery box,
front caster fork hubs and tie downs.
Hydro IHT Mounting .250 in thick 50 ksi steel plates welded to frame tubes.
Control Tower (2) 12 gauge (0.10) thick panels, (1) 10 gauge (right side ) and (2) 0.75 O.D. x
11 gauge (0.12) wall steel tube reference bars. The control tower bolts to the
carrier frame.
Deck Lift System The lift system has 4 contact points. Two at the front of the deck and two rear
of the deck. Lifting is aided by the use of one extension springs. Deck height
adjustments are in 0.25 inch increments from 1.5 inch to 5 inch measured at
the blade tip.
Traction Control Toro Twin Lever Control System
Platform 1.00 O.D. X .120 Wall high strength (50 ksi) steel formed tube welded to 10
gauge (.13) steel sheet. The platform is covered with a vinyl/neoprene anti-
fatigue mat. The platform is able to swing into an upright position and locked
for transport.
Unit Tie Down 3/8 in. diameter rod loop, 4.50 in. wide, welded to rear of frame and sides of
front carrier frame tubes.
To Next Page
Loading...
