Toro GrandStand 74504TE - Removing the Spark Plug; Installing the Spark Plug; Checking the Spark Arrester

TORO®- Grandstand Service Instruction Manual3-18
3
CHASIS
Engine Guard Removal (Figure 16)
1. Remove the 2 nuts on the inside of the engine
guard.
2. Remove the 2 nylon washers on the outside holes
of the engine guard.
3. Pull up to remove the engine guard.
Engine Guard Installation
1. Place the engine guard assembly in the space
between the frame rails.
2. Push the engine guard to one side then insert the
nylon washer in the space on opposite side.
3. Place bolt through the hole in the frame, nylon
washer and engine guard. Secure with a nut.
NOTE: Do not over tighten at this time.
4. On the opposite side of the engine guard assembly,
place bolt through hole in frame, engine guard, and
nylon washer. Secure with nut.