TORO®- Grandstand Service Instruction Manual3-20
3
CHASIS
Frame Removal
1. Remove the deck from the frame, see “Deck
Removal,” page 7-3.
2. Remove the deck lift from the frame.
3. Remove the height of cut assembly from the tower,
see “Height of Cut Removal,” page 3-5.
4. Remove the fuel tank from the tower, see “Fuel Tank
Removal,” page 3-10.
5. Remove the engine from the frame, see “Engine
Removal,” page 5-2.
6. Remove the platform and cushion assembly from
the tower, see “Platform Removal,” page 3-12.
7. Remove the motion controls from the tower, see
“Adjusting Motion Control Levers,” page 4-2.
8. Remove the parking brake from the frame, see
“Parking Brake Removal,” page 3-2.
9. Remove the IHT’s from the frame, see “IHT
Removal,” page 6-6.
10. Remove the wiring harness, see “Wiring Harness
Removal,” page 8-2.
11. Remove the tower from the frame.
12. Remove the casters from the frame, see “Caster
Wheel Assembly Removal,” page 3-7.
Frame Installation
1. Install the brake calipers onto the frame.
2. Install the casters onto the frame, see “Caster
Wheel Assembly Removal,” page 3-7.
3. Install the IHT’s onto the frame, see “IHT
Installation,” page 6-7.
4. Install the deck onto frame lift, see “Deck
Installation,” page 7-3.
5. Install the engine onto the frame, see “Engine
Installation,” page 5-3.
6. Install the tower onto the frame, see “Tower
Installation,” page 3-19.
7. Install the wiring harness onto frame, see “Wiring
Harness Installation,” page 8-2.
8. Install the motion controls into the tower, see
“Adjusting Motion Control Levers,” page 4-2.
9. Install the height of cut assembly onto the tower,
see “Height of Cut Assembly Installation,” page 3-5.
10. Install the platform and cushion on the tower, see
“Platform Installation,” page 3-12.
11. Install the deck onto the tower, see “Deck
Installation,” page 7-3.
12. Level the deck.
13. Install the fuel tank, see “Fuel Tank Installation,”
page 3-10.
14. Set the speed of the IHT’s, see “Speed Setting
Procedure,” page 6-2.
To Next Page
Loading...
