Toro Greensmaster 3150 Series - Setup Procedures; Media and Additional Parts; Installing the Roller; Installing the Ball Studs

Setup
MediaandAdditionalParts
Description
Qty.
Use
Ballstud2Mountthistotheroller.
Operator'sManual
1
Readbeforeinstallingandoperatingthecuttingunit.
Partscatalog1
Usethistoreferencepartnumbers.
InstallingtheRoller
Thecuttingunitisshippedwithoutafrontroller.
Obtainarollerfromyourdealerandinstallitonthe
cuttingunit,asfollows:
1.Removetheplowbolt,washer,andangenut
securingoneoftheheight-of-cutarmstothe
cuttingunitsideplate(Figure3).
g016936
Figure3
1.Height-of-cutarm
4.Washer
2.Adjustingscrew5.Flangenut
3.Plowbolt6.Roller-mountingscrew
2.Loosentheroller-mountingscrewsinthe
height-of-cutarms(Figure3).
3.Slidetherollershaftintotheheight-of-cutarm
ontheoppositeendofthecuttingunit(Figure3).
4.Slidetheheight-of-cutarmontotherollershaft
(Figure3).
5.Looselysecuretherollertothecuttingunitwith
theheight-of-cutarmandfastenerspreviously
removed(Figure3).
6.Centertherollerbetweentheheight-of-cutarms.
7.Tightentheroller-mountingscrews(Figure3).
8.Adjusttothedesiredheight-of-cutandtighten
theheight-of-cutarmmountingfasteners.
InstallingtheBallStuds
Installaballstudoneachendofthefrontroller(Figure
4).
g020075
Figure4
1.Ballstud
InstallingtheHoopLink,
OffsetLink,orChainLink
Forcuttingunitsmountingonatractionunitwitha
serialnumberpriorto240000001,obtainandinstall
theproperliftlinkasfollows:
Note:The2boltsusedtomounttheliftlinkare
shippedinstalledonthecuttingunit.
•ForGreensmaster3120and3150tractionunits,
installthehooplinksuppliedwiththetractionunit.
Installthehooplinktothetopofthecuttingunit
with2bolts.T orquetheboltsto34to40N∙m(25
to30ft-lb)(Figure5).
5