Toro Greensmaster Flex 1018 - Page 141

RemovingtheBedbar
Note:RefertoFigure70duringthisprocedure.
1.Removethecuttingunitfromthemachineandplacethecuttingunitonaat
worksurface;refertoOperator’sManual.
2.Loosenthenuts(11)ontheendofeachbedbaradjusterassembly(1)until
thewashers(9)areloose.
3.Tipthecuttingunittoexposethebedknifeandsupporttherearofthecutting
unit;refertoSupportingtheCuttingUnitwhenServicing(page8–2).
g313909
Figure71
1.Sideplate
6.Bedbar
2.Rubberbushing7.Bedbarpivotbolt
3.Nylonbushing8.Locknut
4.Plasticwasher(2each)9.Bedknife
5.Metalwasher
10.Screw(13each)
4.Loosenthelocknuts(item8inFigure71)oneachbedbarbolt(7).
5.Removethetwobedbarbolts(item7inFigure71),twoatwashers(5)and
fourplasticwashers(4)fromthecuttingunitsideplates(1).
CAUTION
Contactwiththereel,bedknifeorothercuttingunitpartscanresult
inpersonalinjury.Useheavygloveswhenhandlingthebedbar.
6.Removethebedbarassembly(8)fromthecuttingunit.
7.Inspectthenylonbushings(item3inFigure71)andrubberbushings(4)in
thesideplatesforwearordamage.Replacethebushingsifnecessary.
Greensmaster
®
Flex1018/1021
Page8–5
DPACuttingUnits:ServiceandRepairs
20247SLRevA