Toro Greensmaster Flex 1018 - Idler Assembly

IdlerAssembly
g285713
Figure95
1.Socket-headscrew(2each)7.Locknut(2each)
13.Flangenut
2.Bolt
8.Shield14.Clevispin
3.Motoradapter
9.Stubshaft15.Cotterpin
4.Bushing
10.Flockedseal(2each)16.Collar
5.Idlerarm11.Bearing
6.O-ring
12.Retainingring
Note:Thegroomeridlerassemblyislocatedontheoppositesideofthegroomer
gearboxassembly.
RemovingtheIdlerAssembly
1.Removethereeldrivefromthecuttingunit;refertoRemovingtheReel
Assembly(page8–14).
2.Removethegroomerreelassembly;refertoRemovingtheGroomerReel
(page9–15).
3.Removethecotterpinandclevispinfromtheheightadjustmentrodatthe
frontoftheidlerarm.Discardthecotterpin.
4.Removethetwosocket-headscrewsthatsecurethemotoradaptertothe
cuttingunit,andremovetheadapterandidlerassembly.Retrieveand
discardtheO-ringandlocknuts.
5.Inspecttheshields,bearing,andbushingintheidlerassembly.Removeand
discardthecomponentsthatarewornordamaged.
InstallingtheIdlerAssembly
1.Iftheshields,bearing,orbushingwasremovedfromtheidlerarm,install
newcomponentsasfollows:
A.Pressthebushingintoagroomerplateuntilthebushingiscenteredin
theidlerarmbore.
B.Pressthebearingintotheidlerarmsothatthebearingcontactsthe
shoulderinidlerarmboreandinstallthebearingretainingring.
Greensmaster
®
Flex1018/1021
Page9–13
UniversalGroomer(Optional):ServiceandRepairs
20247SLRevA