Toro Greensmaster Flex 1021 - Page 159

InstallingtheFrontRoller(continued)
6.Centerthefrontrollerinthecuttingunitandtightenthepinchboltsthat
securethefrontrollershafttotheheight-of-cutarms.
7.Adjustthecuttingunitheight-of-cut;refertotheCuttingUnitOperator’s
Manual.
RemovingtheRearRoller
g313146
Figure84
1.Rearrollerassembly
4.Spacer
2.Flangenut(2each)5.Shaftretainer
3.Shim6.Socketheadscrew(2each)
RefertoFigure84forthisprocedure.
1.Removethecuttingunitfromthemachineandplaceitonalevelworksurface.
Placeblocksunderthebedbartoraisetherearrolleroffoftheworksurface.
2.Loosentheangenutsthatsecuretherearrollerretainerassemblies(ange
nuts,socketheadscrews,shaftretainer,spacerandshims)tothecuttingunit.
Note:OncuttingunitsequippedwiththeoptionalHighHeight-of-CutKit,
therewillbeadditionalrollershimsinstalledbetweentherearrollerandthe
cuttingunitsideplate.
3.Removeoneoftherearrollerretainerassemblies.
4.Slidetherearrollerassemblyfromtheremainingretainerassembly.
5.Removetheremainingretainerassemblyfromthecuttingunitifnecessary.
InstallingtheRearRoller
RefertoFigure84forthisprocedure.
1.Placethecuttingunitonalevelworksurface.Placeblocksunderthebedbar
toraisetherearofthecuttingunitoffoftheworksurface.
Note:RefertotheCuttingUnitOperator’sManualtodeterminethenumber
ofshimsrequiredforthedesiredheight-of-cutrange.
2.Ifpreviouslyremoved,installoneoftherearrollerretainerassemblies(ange
nuts,socketheadscrews,shaftretainer,spacerandshims)tothecuttingunit.
3.Slidetherearrollershaftintotheretainerassemblyattachedtothecutting
unit.
4.Installtheremainingrearrollerretainerassembly.
Greensmaster
®
Flex1018/1021
Page8–23
DPACuttingUnits:ServiceandRepairs
20247SLRevA