Toro Greensmaster TriFlex 3420 - Installing the Roll Bar; Installing the Seat

Description
Qty.
Use
Pre-deliveryInspectionSheet
1
Noiseratingcerticate
1
Certicateofcompliance
1
Saveforfuturereference
Ignitionkeys2
Starttheengine.
1
InstallingtheRollBar
Partsneededforthisprocedure:
1Rollbar
4
Bolt(1/2x3-3/4inches)
4
Flange-nut(1/2inch)
Procedure
1.Removethetopcratesupportfromthecrate.
2.Removetherollbarfromthecrate.
3.Installtherollbarintothepocketsoneachside
ofthemachine,using4bolts(1/2x3-3/4inches)
and4ange-nuts(1/2inch)asshowninFigure
3.
g014601
Figure3
1.Rollbar
3.Flange-nut(1/2inch)
2.Bolt(1/2x3-3/4inches)
4.Torquethefastenersto136to149N∙m(100to
110ft-lb).
2
InstallingtheSeat
Partsneededforthisprocedure:
1
Seat
1
Seatwireharness
Procedure
Note:Mounttheseatinthefrontsetofmounting
holestogainanadditional7.6cm(3inches)inthe
forwardadjustment,orintherearmountingholes
foranadditional7.6cm(3inches)intherearward
adjustment.
1.Removeanddiscardthelagboltssecuringthe
seatslidesandcuttheshippingstraps.
2.Removethe4bolts(5/16x3/4inch)and
washersfromtheshippingbracketanddiscard
thebracket.
3.Securetheseattotheseatbasewith4bolts
andwashersremovedpreviously(Figure4).
13