Groundsmaster 3500--D Hydraulic System (Rev. D)Page 4 -- 63
Hydraulic Tank Removal
1. Drain hydraulic oil from Hydraulic tank (see Change
Hydraulic Fluid).
2. Remove hydraulic tank using Figure 41 as a guide.
Discard and replace any o--rings that are removed.
Hydraulic Tank Inspection (Fig. 41)
1. Clean hydraulic tank and suction strainer with sol-
vent.
2. Inspect hydraulic tank for leaks, cracks, or other
damage.
Hydraulic Tank Installation
1. Apply anti--seize lubricant or equivalent to the two
flange head screws that secure the hydraulic tank.
Tighten the tank mounting screws from 30 to 60 in--lb
(3.4 to 6.8 N--m). Install tank using Figure 41 as a guide.
2. Thread suction strainer into hydraulic tank. Note:
Early models used a two piece suction strainer assem-
bly. On early models only, use hydraulic thread sealant
on threads of suction strainer and barb fittings during re-
assembly. Do not apply sealant to the first thread of the
fittings.
3. Using a wrench, turn strainer into tank port at least
1--1/2 to 2 full turns beyond finger tight.
4. Fill hydraulic tank with new hydraulic fluid (see
Change Hydraulic Fluid).
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
System
Electrical
System
Wheels, Brakes,
and Chassis
To Next Page
Loading...
