Rev. DGroundsmaster 3500--D Page 6 -- 3 Wheels, Brakes,and Chassis
Adjustments
Adjust Brake Lever
Brake lever adjustment should be checked every 200
hours.
CAUTION
Before and after adjusting the brakes, always
check the brakes in a wide open area that is flat
and free of other persons and obstructions.
1. Park machine on a level surface, lower cutting units,
stop engine, and remove key from the ignition switch.
2. Loosen set screw on the adjustment knob (Fig. 1).
3. Adjust travel of brake lever until a force of 30 to 40 lbs
(133 to 178 N) is required to actuate lever:
A. Turn adjustment knob clockwise to increase
force.
B. Turn adjustment knob counterclockwise to de-
crease force.
4. Tighten set screw after adjustment has been at-
tained.
1. Brake lever
2. Set screw
3. Adjustment knob
Figure 1
2
3
1
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
Systems
Electrical
Systems
Wheels, Brakes,
and Chassis
To Next Page
Loading...
