Rev. E
Groundsmaster 3500--DPage 7 -- 4Cutting Units (Rev. D)
Special Tools
Order these special tools from your Toro Distributor.
Cutting Unit Tool Kit - TOR4070
This tool kit includes special tools used to assemble the
cutting unit rear roller that has greasable bearings with
a grease fitting on the ends of the roller shaft.
TOR4064 Spanner Wrench
TOR4065 Inner Oil Seal Installer
TOR4066 Bearing Installer
TOR4067 Shaft Support Tool
TOR4068 Inner Seal Installer
TOR4869 Outer Seal Installer
TOR4071 Outer Oil Seal Installer
TOR4072 Shaft Seal Protector
TOR4073 Handle
TOR4074 Spline Insert Tool
Figure 1
Rear Roller Grease Nozzle -- 107--1998
This tool is used to grease the cutting unit rear roller
bearings when equipped with a grease fitting on the
ends of the roller shaft.
Figure 2
Rear Roller Bearing and Seal Installation Tools
These tools are used to assemble the cutting unit rear
roller that has greasable bearings and a bearing lock nut
used to retain the bearings.
115--0852 Inner Seal Tool
115--0853 Bearing/Outer Seal Tool
107--8133 Bearing Installation Washer
Figure 3
Inner Seal
Tool
Bearing/Outer Seal
Bearing Installation
Washer
Tool
To Next Page
Loading...
