Groundsmaster 3500--D Page 5 -- 1 5 Electrical System (Rev. D)
Cutting Unit Drive Switch
The cutting unit drive switch is located on the control
panel (Fig. 19). This rocker switch allows the decks to be
engaged or disengaged. Along with additional switches
in the interlock system, the cutting unit drive switch con-
trols the solenoid valve on the hydraulic manifold.
The switch terminals are marked as shown in Fig. 20.
The circuitry of the ignition switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
position. Verify continuity between switch terminals.
SWITCH
POSITION
NORMAL
CIRCUITS
OTHER
CIRCUITS
ENGAGE 5+6 2+3
DISENGAGE 1+2 4+5
1. Control panel 2. Cutting unit drive switch
Figure 19
1
2
Figure 20
132
45 6
Back of Cutting Unit Drive Switch
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
Systems
Electrical
System
To Next Page
Loading...
