Groundsmaster 3500--D Hydraulic System (Rev. D)Page 4 -- 107
Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor -
mation section.
1. Remove steering control valve from the s teering col-
umn using Figures 74, 75, and 76 as guides.
Installation
1. Install steering control valve to the steering column
using Figures 74, 75, and 76 as guides. When installing
steering control valve, note position of end cover protru-
sion as shown (Fig. 76).
2. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Check Hydraulic System Fluid).
1. Tilt bracket
2. Steering valve bracket
3. Jam nut
4. Flat washer
5. Friction disc
6. Steering tilt lever
7. Steering arm
8. Friction disc
Figure 75
2
6
8
1
3
4
5
7
1. Cap screw
2. Flange nuts
3. Steering valve bracket
4. Steering arm
5. Steering control valve
6. Steering tilt lever
7. End cover protrusion
Figure 76
5
6
4
3
7
1
2
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
System
Electrical
System
Wheels, Brakes,
and Chassis
To Next Page
Loading...
