Toro Groundsmaster
3500-D - Page 161

Groundsmaster 3500--D Hydraulic System (Rev. D)Page 4 -- 111
Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor -
mation section.
1. Remove hydraulic cylinder from the frame using Fig-
ure 79 as guide.
2. If hydraulic fittings are to be removed from cylinder,
mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed from cylinder,
install fittings to cylinder using marks made during the
removal process to properly orientate fittings.
2. Install hydraulic cylinder to the frame using Figure 79
as guide.
3. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Check Hydraulic System Fluid).
4. Adjust scissors mount as follows:
A. Shift sidewinder fully to the left (fully retract cylin-
der).
B. Loosen four cap screws and locknuts securing
the scissor mount to lower frame.
C. The gap between the scissor frame and lower
frame and the gap between the scissor frame and
the sidewinder carrier must be equal distances with-
in 0.060 inch (1.5 mm).
D. Tighten four cap screws and lock nuts to secure
the scissor mount.
1. Scissor frame
2. Lower frame
3. Sidewinder carrier
4. Gaps
Figure 80
4
2
1
3
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
System
Electrical
System
Wheels, Brakes,
and Chassis