Groundsmaster 3500--D
Page 2 -- 10
Product Records and Maintenance
Cutting Units
Each cutting unit has two grease fittings per blade
spindle. Either fitting can be used for greasing, which
ever is more accessible. Under normal conditions, lubri-
cate spindle bearings with No. 2 General Purpose Lithi-
um Base Grease or Molybdenum base grease, after
every 50 hours of operation.
IMPORTANT: Lubricate cutting units immediately
after washing. This helps to purge water out of bear-
ings and increases bearing life.
1. Wipe grease fitting with a clean rag.
IMPORTANT: Do not apply too much pressure or
grease seals will be permanently damaged.
2. Apply grease until a small amount appears at bottom
of spindle housing (under deck).
3. Wipe excess grease away.
Figure 13
To Next Page
Loading...
