Groundsmaster 3500--D Page 6 -- 15 Wheels, Brakes,and Chassis
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove control panel cover from the machine.
IMPORTANT: When removing the adjustable clevis
from either the brake pivot shaft or adjustment rod
or the brake lever from the cam shaft on the brake
assembly, make sure to matchmark both parts.
Marking both parts will make reassembly and brake
adjustment easier.
3. Remove and replace parts as necessary to repair
brake linkages.
4. Install control panel cover to the machine.
IMPORTANT: Always check and adjust brakes any-
time brake linkages are disassembled or repaired.
5. Adjust brake linkages (see Adjust Brakes).
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
Systems
Electrical
Systems
Wheels, Brakes,
and Chassis
To Next Page
Loading...
