Groundsmaster 3500--D
Page 3 -- 22
Kubota Diesel Engine
Clean Radiator and Oil Cooler (Fig. 25)
The radiator and oil cooler should be checked for dirt
and debris daily, and hourly if conditions are extremely
dusty and dirty.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
CAUTION
If engine has been running, the radiator may be
hot and cause burns. Work on radiator only when
the engine and radiator are cool.
2. Unlatch and open engine hood.
3. Clean engine area thoroughly of all dirt and debris.
4. Remove lower radiator shield. Release wire form
latch and allow oil cooler to pivot out (Fig. 26).
5. Clean both sides of oil cooler and radiator area thor-
oughly with water or compressed air.
6. Pivot oil cooler back and latch into position. Install
lower shield. Close and latch hood.
Figure 25
1. Oil cooler
2. Radiator
3. Wire form latch
2
1
3
Figure 26
1. Oil cooler (pivoted out)
2. Radiator
3. Wire form latch
3
1
2
To Next Page
Loading...
