Groundsmaster 3500--DHydraulic System (Rev. D) Page 4 -- 24
O--Ring Kit
Toro Part Number: 16--3799
The kit includes o--r ings in a variety of sizes for face seal
and port seal hydraulic connections. It is recommended
that o--rings be replaced whenever a hydraulic connec-
tion is loosened.
Figure 14
Wheel Hub Puller
Part Number: TOR4097
The wheel hub puller allows safe removal of the wheel
hub from the shaft of wheel motors.
Figure 15
High Pressure Hydraulic Oil Filter
If a component failure occurs in the closed loop traction
circuit, contamination from the failed part will remain in
the circuit until removed. When connecting hydraulic
test gauges in order to test traction circuit c omponents
or after replacing a failed traction circuit component (e.g.
hydrostat or wheel motor), a high pressure hydraulic fil-
ter can be installed in the traction circuit. The filter will
ensure that contaminates are removed from the closed
loop and thus, do not cause additional component dam-
age.
A high pressure hydraulic oil filter can be obtained local-
ly.
Figure 16
To Next Page
Loading...
