Toro LC175FDS - Engine Oil Change Procedure

10
Engine Oil Change Procedure
1. Run engine to warm engine oil.
2. Remove the ignition key.
3. Remove oil dipstick.
4. Position oil drain pan under oil drain plug.
5. Firmly hold the oil drain tube (A) in position. Remove the oil drain plug (B).
6. Completely drain the engine oil.
7. Firmly hold the oil drain tube (A) in position. Install the oil drain plug (B) - torque to 17 ft-lbs (23 Nm).
8. Add oil through the dipstick tube. Wipe the dipstick clean and fully insert it into the dipstick tube.
9. Remove the dipstick and check the oil level – Add oil if needed until the proper oil level is reached
NOTE: DO NOT overfill the engine oil
10. Fully install the dipstick.
11. Properly dispose of the used engine oil.
Engine Oil Capacity:
30 to 32 oz. (0.89 to 0.95 l)
Engine Oil Type:
API classification of SF,SG, SH, SJ, SL, or higher.
A
B