Toro LDC-6 - Setting the Time and Date; Setting the Controller Time; Setting the Controller Date

7
SETTING THE TIME AND DATE
1 Select Set Clock/Calendar on the Control Dial.
This will cause the HOUR to flash.
2 Use the and buttons to adjust the
hour to the correct value. Note that the clock is
12 hour so ensure that the correct AM or PM is
displayed.
3 Press and MIN will flash.
4 Use the and buttons to adjust the
minutes to the correct value.
1 Select Set Clock/Calendar on the Control Dial.
This will cause the HOUR to flash.
2 Press and DAY will flash.
3 Use the and buttons to adjust the day
to the correct value.
4 Press and MONTH will flash.
5 Use the and buttons to adjust the
month to the correct value.
6 Press and YEAR will flash.
7 Use the and buttons to adjust the
year to the correct value.
PM
9: 27
HOUR MIN
TUE
DAY
2015
YEAR MONTH
TUE
9 15
ODD
Note: If the 9V backup battery is not fitted, or is flat, when mains power is lost, the controller memory
updates every 10 minutes. When power is restored, the clock resumes at the last updated time, which may
dier from the correct time by up to 10 minutes.
Control Switch
SETTING THE TIME SETTING THE DATE