Toro Reelmaster 5410 - Installing the CE Hood Latch; Using the Cutting Unit Kickstand

7
InstallingtheCEHoodLatch
Partsneededforthisprocedure:
1Hoodlatchassembly
1Washer
Procedure
1.Unlatchandraisethehood.
2.Removetherubbergrommetfromtheholeinthe
leftsideofthehood(Figure16).
Figure16
1.Rubbergrommet
3.Removethenutfromthehoodlatchassembly
(Figure17).
Figure17
1.Hoodlatch3.Rubberwasher
2.Nut4.Metalwasher
4.Outsidethehood,insertthehookendofthelatch
throughtheholeinthehood.Makesuretherubber
sealingwasherremainstotheoutersideofthehood.
5.Insidethehood,insertthemetalwasherontothe
latchandsecurewiththenut.Makesurethelatch
engagestheframecatchwhenitislocked.Usethe
enclosedhoodlatchkeytooperatethehoodlatch.
8
UsingtheCuttingUnit
Kickstand
Partsneededforthisprocedure:
1
Cuttingunitkickstand
Procedure
Wheneverthecuttingunithastobetippedtoexposethe
bedknife/reel,propuptherearofthecuttingunitwith
thekickstandtomakesurethenutsonthebackendof
thebedbaradjustingscrewsarenotrestingonthework
surface(Figure18).
Figure18
1.Cuttingunitkickstand
Securethekickstandtothechainbracketwiththe
snapperpin(Figure19).
21