Toro Reelmaster 5500-D - Flow Divider

Hydraulic
System
Reelmaster 5500-D Hydraulic System (Rev. C)Page 4 - 85
Flow Divider
The lift circuit for the front, outer lift cylinders includes a
flow divider. This flow divider provides for even lifting of
cutting units #4 and #5. The lift speed of #4 and #5 cut-
ting units should be similar when the flow divider is func-
tioning correctly. The flow divider assembly mounts to
the front carrier frame (Fig. 93).
The flow divider on early production machines consists
of a three (3) port manifold and a flow divider cartridge.
The flow divider on later production machines includes
a solenoid cartridge valve and two (2) flow regulator car-
tridges (Fig. 94).
If necessary, the cartridges can be carefully removed
from the manifold for cleaning.
1. Flow divider
2. O−ring
3. Hydraulic fitting
4. O−ring
5. Hydraulic hose
6. Cap screw (2 used)
7. Flat washer (2 used)
8. Hydraulic fitting
9. Hydraulic hose
10. Front carrier frame
11. Lock nut (2 used)
Figure 93
6
7
3
5
4
1
2
10
8
2
2
4
4
8
9
11
1. Manifold
2. Solenoid cartridge valve
3. Flow regulator cartridg
e
Figure 94
2
3
1
20 to 25 ft−lb
(27 to 34 N−m)
4
30 to 35 ft−lb
(41 to 47 N−m)
50 to 55 in−lb
(5.6 to 6.2 N−m)