Toro Reelmaster 5500-D - Groomer Height of Cut Assembly

Reelmaster 5500−DGroomer (Rev. C) Page 8.1 − 12
Groomer Height of Cut Assembly
Figure 15
1. Groomer reel assembly
2. Grease seal
3. Bearing
4. Height of Cut screw
5. Washer
6. Lock nut
7. Grease fitting
8. Bearing housing
9. Grease seal
10. Adjustment bracket
11. Height of Cut bracket
12. Height of Cut bracket
13. Adjustment bracket
14. Retaining ring
15. Plug
16. Grease seal
17. Seal guard
1
3
5
2
6
4
7
15
16
8
17
13
14
12
9
10
11
6
2
3
4
5
5
5
6
6
6
7
17
17
Note: The groomer reel drive is located on the oppo-
site side of the cutting unit from the cutting reel hydraulic
motor. Figure 15 shows components used when the
groomer reel drive is on the left side of the cutting unit.