Toro Titan Z5200 - Page 134

HYDROSTATIC DRIVE SYSTEM
7-72007 - 2008 Titan Z Service Manual
7
Motion Control Damper Replacement
Motion Control Damper Removal
1. Raise the seat.
2. Remove the negative and then the positive battery
cable from the battery.
3. Loosen the two wing nuts on the battery hold down
bolts. Remove the battery from the machine (Fig.
380).
5. Remove the motion control damper from the
machine (Fig. 382).
4. Remove the two nuts securing the motion control
damper to the frame and the motion control pivot
(Fig. 381).
Fig. 380 IMG-0456
Fig. 381 IMG-0457
Fig. 382 IMG-0460