Toro Titan Z5200 - Page 135

HYDROSTATIC DRIVE SYSTEM
7-8 2007 - 2008 Titan Z Service Manual
7
Motion Control Damper Installation
1. Install two nuts on each screw of the motion control
damper (Fig. 383).
3. Install a nut on each end of the damper to secure
(Fig. 385).
Fig. 383 IMG-0468a
 ,QVWDOOWKH¿[HGHQGRIWKHGDPSHUWRWKHIUDPH
Install the rod end of the damper to the motion
control pivot (Fig. 384).
Fig. 384 IMG-0476
Fig. 385 IMG-0477
4. Position the battery into the machine. Install the
battery hold down to secure (Fig. 386).
Fig. 386 IMG-0456
5. Install the positive and then the negative battery
cable to the battery.
6. Lower the seat.