MOWER DECK
5-8 2007 - 2008 Titan Z Service Manual
5
Idler Arm Assembly Replacement
Idler Arm Assembly Removal
3. Remove the other end of the spring extension from
the idler arm (Fig. 258).
Fig. 258 IMG-0656a
14. Check that the mower deck belt is routed properly.
Refer to the belt routing decal (Fig. 255):
16. Install the mower deck to the machine. Refer to
“Mower Deck Installation” on page 5-19.
1. Remove the mower deck from the machine. Refer to
“Mower Deck Removal” on page 5-18.
2. With a spring tool (Toro part number 92-5771)
remove the extension spring from the spring post
located at the rear of the mower deck (Fig. 257).
Fig. 255 109-6035
Fig. 257 IMG-0655
15. Position the belt cover onto the mower deck. Install
two nuts to secure (Fig. 256).
Fig. 256 IMG-0611
To Next Page
Loading...
