Toro TX 427 - Engine Oil and Filter Service; Engine Oil Specifications and Level Check; Purge-Line Filter Replacement

ReplacingtheCarbon-Canister
Purge-LineFilter
ServiceInterval:Every200hours—Replace
thecarbon-canisterpurge-linelter
(Servicemorefrequentlywhenusing
thevibratory-plowattachment).
Note:Checkthepurge-linelteroccasionallyfordirt.
Ifthelterappearstobedirty,replaceit.
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,andlowertheloaderarms.
2.Shutofftheengineandremovethekey.
3.Removetherear-accesscover.
4.Movethespring-typehoseclampsonbothsides
ofthecarbon-canisterpurge-linelterawayfrom
thelter(Figure33).
5.Removeanddiscardthepurge-linelter(Figure
33).
6.Installanewlterintothehosewiththearrowon
thelterpointingawayfromthecarboncanister
andsecureitwiththehoseclamps(Figure33).
7.Installtherear-accesscover.
ServicingtheEngineOil
ServiceInterval:Beforeeachuseordaily—Check
theengine-oillevel.
Aftertherst50hours—Changetheengineoil
andlter.
Every100hours—Changetheengineoil.
(Servicemorefrequentlyifconditionsare
extremelydustyorsandy.)
Every200hours—Changetheoillter.(Service
morefrequentlyifconditionsareextremely
dustyorsandy.)
Engine-OilSpecications
OilType:Detergentoil(APIserviceSG,SH,SJ,or
higher)
CrankcaseCapacity:withlter,2.0L(2.1USqt)
Viscosity:Seetablebelow
g000650
Figure34
CheckingtheEngine-OilLevel
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,andlowertheloaderarms.
2.Shutofftheengine,removethekey,andallow
theenginetocool.
3.Openthehood.
4.Cleantheareaaroundtheoildipstick(Figure
35).
g004172
Figure35
1.Oildipstick
2.Metalend
5.Pulloutthedipstickandwipethemetalend
clean(Figure35).
6.Slidethedipstickfullyintothedipsticktube
(Figure35).
7.Pullthedipstickoutandlookatthemetalend.
8.Iftheoillevelislow,cleanaroundtheoil-llcap
andremovethecap(Figure36).
28