15
STEP 6 - Set Program Start Times
The sixth and final step is to determine the time of day you want to start a
watering program. Each program can be started up to 3 times per scheduled
watering day. Start times are set by the position of the program start time
controls. The upper controls set Program “A” start times and the lower controls
set Program “B” start times.
When selecting start times, please keep in mind the following operational
characteristics:
– A start time initiates a complete program cycle, not an individual station.
– A start time can only be set to occur on the hour or in ten minute increments
past the hour, such as 3:00, 3:10, 3:20 etc.
– If the same start time is selected in both programs, the “A” program will run
first. Upon its completion, the “B” program will start. Both programs cannot
operate at the same time.
– A start time which occurs during a watering program already in progress will
be delayed until the program in progress is finished.
– The earliest start time will always occur first regardless if set for Program A
or Program B.
Use the following procedure to select program start times.
❑ Position all start time controls to left
(OFF). Slide first control
slowly to
right until display shows start time.
Note: Display shows Start Time for
5 seconds after control is moved.
❑ Slide control in either direction to
display exact start time (Example
shown: 8:00 p.m.).
❑ Repeat this procedure for all
additional start times in both
programs.
To Next Page
Loading...
Need help?
General
