Workman HD Series
Page 6 -- 59
Drive Train
Assembly (Fig. 114)
NOTE: Item numbers in figures are shown in reverse
order of assembly; for example, when assembling,
installitem1last.
1. Clean gasket material from mating surfaces of hous-
ing and cover.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Make sure all parts are free of dirt and dust.
3. Assemble shift arm:
A. Apply moly disulfide grease to two (2) new O--
rings (item 1) and install onto shift arm.
B. Apply moly disulfide grease to arm pin and shaft.
C. Install shift arm into PTO housing.
D. Install shift lever onto shift arm.
E. Drive two (2) spring pins into shift lever and shift
arm. Pay attention to direction of slit in spring pins.
1
2
3
Figure 129
Figure 130
Figure 131
Drive Train
To Next Page
Loading...
