Toro Workman HDX - Page 136

Workman HD Series
Page 6 -- 60
Drive Train
4. Assemble PTO output shaft:
A. If bearing (item 6) was removed, use a press to
install bearing onto output shaft.
B. Install washer (item 5) and retaining ring (item 4).
C. Install retaining ring (item 3) and gear (item 2).
D. Use a press to install bearing (item 1).
5. Use a press to install bearing (item 1) onto intermedi-
ate shaft.
6. Assemble PTO input shaft:
A. Insert spring (item 3) and two (2) steel balls (item
2) into hole.
B. Insert shift collar (item 1) onto input shaft.
C. Move shift collar to ”ON” position.
1
2
3
7
6
4
5
Figure 132
Figure 133
1
Figure 134
1
2
2
3
Figure 135