Workman HD Series
Page 6 -- 63
Drive Train
10.Install PTO cover:
A. Insert new oil seal into PTO cover. Apply multi--
purpose grease to lip of oil seal.
B. Insert two (2) alignment pins into PTO housing.
C. Apply s ilicone sealant onto mating surface of PTO
cover.
D. Install PTO cover. Secure cover with cap screws,
nut and lock washers. Torque fasteners from 18 to 22
ft--lb (24.5 to 29.5 N--m).
11. Install PTO to transaxle (see PTO Removal and
Installation in this section).
Figure 143
Drive Train
To Next Page
Loading...
