g027343
Figure86
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe7.6cm
(3inch)height-of-cutlocation.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(Postion
A)asshowninFigure87.
Note:Themeasurementshouldread7.6mm
(3inches)
g009196
Figure87
1.7.6cm(3inches)at
positionAiscorrect.
3.Measureherefromthe
bladetiptothehard
surface.
2.8.3cm(3-1/4inches)at
positionBiscorrect.
4.MeasureatpositionAand
Bonbothsides.
10.Ifneeded,loosenthewhizlocknutonthesideof
theyokeandthejamnutontop(Figure88).
11.Fine-tunethescrewadjusterbyturningittoget
7.6mm(3inches)height.
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,you
canutilizethesingle-pointadjustmenttogain
moreadjustment.
g010251
Figure88
1.Whizlocknut3.Jamnut
2.Adjusterscrew4.Yoke
64
To Next Page
Loading...
