ENGLISH ( EN )
22
1. FRONT DISPLAY SETTINGS
2. DISPLAY MESSAGES
Control settings knob
(1)
Overload setting
Datalogger
and advanced
options
Low level
Pump ON
Underload setting
Restart time setting
Inhibition time setting
(ow switch or reverse
pressure switch)
Alarm
0ff
Pump stopped.
Auto
Automatic mode activated.
9.3 A
Pump power consumption (A).
3H
Time in hours.
42
Time in minutes.
35
Time in seconds (ow switch inhibition).
x1gx frec
Excessive frequency of starts.
Err. PHa5
Phase failure or abnormal current absorbed by the pump (+40% of
the current threshold set in Imax).
xand
Manual reset after a water shortage (without reset time set).
5et
Enter the “Datalogger and advanced options” menu.
data
Datalogger.
ea5y
“Easy” mode activated.
f. re5
Reset the unit to factory defaults (Factory Reset).
End
Exit “Datalogger and advanced options”.
II
I
(1)
The rotative pushbutton is used to congure the various setting parameters (selection/
modication/conrmation), to select the MAN-OFF-AUTO operating mode, to reset a
motor failure or to interrupt a timer in progress (see pages 35 to 37)
Distribuido por Adajusa
To Next Page
Loading...
Need help?
General