ENGLISH ( EN )
38
18. RESET TO FACTORY SETTINGS
19. ADITIONAL PROTECTIONS
Select Press
Conrm
Turn right
After this operation the equipment returns to the factory default settings.
Excessive start frequency detection
After a start the pump needs at least 120 seconds to assume the initial effort. If a new start
appears before the end of this time the temperature of the pump increase.
In the event of more that 30 sucessive starts preventing the pump to cool down, the excessive
start frequency alarm is activated. The pump stops, the alarm output is activated and the display
shows the message [FrEc- HIGH].
Anti-lock system. Jammed impeller preventive syst
Every 23 hours Vigilec Compact will run the pump for 1 second avoiding blockage of the
pump motor. Intended to avoid possible failures after long inactivity periods.
Phase failure protection (three phase pumps)
If in a three-phase installation one of the phases is interrupted or missing, in the power
supply to the equipment or in the output to the pump, a phase failure will occur. The
unit detects the problem and displays the fault [PHA]-[Err]. In order for this fault to be
detected, the underload setting (Imin) must not be set in “OFF”.
Overvoltage protection
If the power supply exceeds the nominal value by more than 30%, the equipment stops
its operation. When the voltage returns to the correct value, operation will be restored.
Note: The counters of hours, starts, alarms and current of the last alarm will not be deleted.
PUSH
Auto0
<4s
PUSH
Auto0
<4s
PUSH
Auto0
<4s
Imin
Imax
Imin
Imax
Imin
Imax
PUSH
Auto0
<4s
Imin
Imax
HOLD DOWN
AND DO NOT
RELEASE FOR 8 SEC
Distribuido por Adajusa
To Next Page
Loading...
Need help?
General