Toshiba 40RV700A - Manual Channel Tuning Methods

15
Getting started
4 Select Auto Scan and press ► or .
Auto Scan
Update Scan
Single RF Scan
Channel Skip
Channel Sort
Channel Edit
Channels
Select Back Exit
EXIT
Scan
OK RETURN
5 Press Cancel for no change, or press to start Auto
Scan.
Pr eviou s settings will be lost ! Press
Ca ncel for no change, Press OK to start
Au to sc an.
OK Cancel
Update Scan
Search the new channels that are not in the programme
list.
1 Press and then press ◄ or ► to select SETUP.
2 Press ▲ or ▼ to highlight Channels. Press ► or
to enter.
3 Select Update Scan. Press to start Update Scan.
Auto Scan
Update Scan
Single RF Scan
Channel Skip
Channel Sort
Channel Edit
Channels
Select Back Exit
EXIT
Enter
OK RETURN
Note: This option is available for DVB_T only.
Single RF Scan
Scan single RF channel. You can check the Signal
Strength and the Signal Quality.
1 Select Channels from the SETUP menu.
2 Highlight Single RF Scan and press ► or to
enter.
Auto Scan
Update Scan
Single RF Scan
Channel Skip
Channel Sort
Channel Edit
Channels
Select Back Exit
EXIT
Enter
OK RETURN
3 Press ◄ or ► to select the RF Channel. Press to
start scanning.
100
Single RF Scan
BackScan Exit
EXITOK RETURN
Scan single RF channel. (Digital Only)
RF Channel
Signal Strength
signal Quality
8
Good
0%
Analogue Manual Scan
The television can be tuned-in manually using Analogue
Manual Scan.
1 Press and then press ◄ or ► to select SETUP.
2 Press ▲ or ▼ to highlight Channels. Press ► or
to enter.
3 Select Analogue Manual Scan. Press ► or to
confirm.
Auto Scan
Update Scan
Analogue Manual Scan
Channel Skip
Channel Sort
Channel Edit
Analogue Channel Fine Tune
Channels
Select Back Exit
EXIT
Enter
OK RETURN
4 Use number buttons 0~9 to enter the Start
Frequency. Press ▲ or ▼ to select Scan Up or Scan
Down. Press ► or to start scanning. Press
RETURN
to
stop scanning.
Analogue Manual Scan
Back Exit
EXITRETURN
Search for analogue channels
Start Frequency (MHz) 175.25
Scan Up
Scan Down