Toshiba 40RV700A - Cinema Mode; Dnr; Mpeg Nr; Cti

22
Using the TV’s features (General)
Cinema Mode
The frame rate of a movie film is generally 24 frames a
second whereas the movie software such as DVD, etc.
that you enjoy watching on television at home is 30 or
25 frames a second. The difference in frame rate may
cause flickers whilst viewing the films on television; set
the Cinema Mode to convert the signal to reproduce a
smooth motion and picture quality.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video, press ► or to select.
Picture Mode User
50
95
50
0
50
Brightness
Contrast
Colour
Tint
Sharpness
PICTURE
60Back Light
Picture Size
Colour Temperature
Advanced Video
Wide
Select Back Exit
EXIT
Enter
OK RETURN
2 Press ▲ or ▼ to highlight Cinema Mode, press ◄ or
► select On or Off.
7
Advanced Video
Select Back Exit
EXITRETURN
OnCinema Mode
Auto
Off
Off
NR
CTI
Adaptive Luma Control
OnActive Backlight
Blue Screen
3D Colour Management
Base Colour Adjustment
DNR
DNR (Digital Noise Reduction) enables you to ‘soften’
the screen representation of a weak signal to reduce the
noise effect.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video, press ► or to select.
2 Press ▲ or ▼ to highlight NR and then press ► or
to select.
3 Select DNR. Press ◄ or ► to select Low, Middle,
High, Auto, or Off.
NR
Select Back Exit
EXITRETURN
Auto
Low
DNR
MPEG NR
MPEG NR
If the receiving signal of MPEG is a grained noise
depending on the compression and conversion, the noise
may be reduced when using this function.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video, press ► or to select.
2 Press ▲ or ▼ to highlight NR and then press ► or
to select.
3 Select the MPEG NR, and press ◄ or ► to select On
or Off.
NR
Select Back Exit
EXITRETURN
Auto
Low
DNR
MPEG NR
CTI
The colour transient improvement (CTI) involves the
detection and sharpening of edges around colour objects
on the screen.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video and press ► or to select.
2 Select the CTI, and press ◄ or ► to select Auto or
Off.
Adaptive Luma Control
Automatically adjusts the brightness and contrast after
analyzing the input signal. This function enriches the
colours and the depth of the picture.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video and press ► or to select.
2 Press ▲ or ▼ to highlight Adaptive Luma Control
and then press ◄ or ► to select from 0 ~ 10.
Active Backlight
When Active Backlight is activated, it will automatically
optimise the backlighting levels for dark scenes.
1 In the PICTURE menu, press ▲ or ▼ to highlight
Advanced Video and press ► or to select.
2 Select the Active Backlight, and press ◄ or ► to
select On or Off.