Toshiba 40RV700A - Using the PC Setting; Adjusting the Picture Settings; PC of the Auto Adjust

39
Connecting your TV
• Depending on the specication of the PC you are
playing the DVD-Video on, and the DVD’s title, some
scenes may be skipped, or you may not be able to
pause during multi-angle scenes.
Signal names for mini D-sub 15 pin connector
5
10 6
15 11
1
Pin assignment for RGB/PC terminal
Pin No. Signal name Pin No. Signal name
1 R 9 VGA-5V
2 G 10 Ground
3 B 11 NC (not connected)
4 NC (not connected) 12 VGA-SDA
5 NC (not connected) 13 H-sync
6 Ground 14 V-sync
7 Ground 15 VGA-SCL
8 Ground
Using the PC setting
• First press to display the video input source list,
then press ▲ or ▼ and in order to select the PC
input mode ( page 27).
• This function may not be available for some signal or if
no signal is received.
• The optimum points of the clock phase and sampling
clock adjustments may be incomprehensible according
to the input signals.
Adjusting the picture settings
1 Press and use ◄ or ► to select PICTURE.
2 Use ▲ and ▼ to select PC and press ► or .
3 Use ▲ or ▼ to select an option and press ◄ or ► to
adjust the setting as required.
PC of the Auto Adjust
Adjust Horizontal Position, Vertical Position, Horizontal
Clock, and Clock Phase automatically. Depending on the
type of the signal, there is a possibility that the display
may not be adjusted in its optimum condition with this
function. In that case, please adjust each item manually.
1 Press and use ◄ or ► to select PICTURE.
2 Use ▲ and ▼ to select PC and press ► or .
3 Use ▼ to highlight Auto Adjust and press .