EasyManua.ls Logo

Toshiba 40RV700A - Computer and REGZA-LINK Connectivity

Toshiba 40RV700A
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
Connecting your TV
Standard analogue audio cables
An HDMI-to-DVI adapter cable transfers only video.
Separate analogue audio cables are required.
When connecting a DVI device, please connect to the
HDMI 1 port only.
Note:
HDMI, the HDMI logo, and High-Definition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing, LLC in the United States
and other countries.
REGZA-LINK Connections
The basic functions of connected audio/video equipment
can be controlled using the television's remote control if
a REGZA-LINK compatible device is connected.
Connection example:
22AV700A/26AV700A/32AV700A
HDMI 1/2
1
2
AV amplifier
HDMI out
Playback equipment
HDMI outHDMI in
Playback equipment
HDMI out
TV back view
32CV700A/40CV700A/40RV700A
HDMI 1/2/3
1
2
3
AV amplifier
HDMI out
Playback equipment
HDMI outHDMI in
Playback equipment
HDMI out
TV back view
Notes:
It is recommended that for correct operation all audio/
video devices are connected using HDMI cables
branded with the HDMI logo ( ). If several
devices are connected, the REGZA-LINK feature may
not operate properly. After connecting the equipment
use the REGZA-LINK menus to setup the desired op-
tions. The connected equipment must also be set. For
details see the operation manual for each connected
device.
The REGZA-LINK feature uses CEC Technology as
regulated by the HDMI standard. This feature is limited
to models incorporating Toshiba’s REGZA-LINK.
However,Toshiba is not liable for those operations.
Refer to individual instruction manuals for compatibility
information.
Connecting a computer
An analogue RGB (15 pin) computer cable can be
connected.
RGB/PC
PC / HDMI(1)
AUDIO
TV back view
Mini D-sub
15 pin
Conversion adapter
(if necessary)
Computer
RGB PC cable
Audio cable for
PC-to-TV
connection
Connect a PC cable from the computer to the RGB/PC
terminal on the back of the TV.
For acceptable PC signal formats ( page 40).
However, these signal formats are converted to match
the number of pixels of the LCD panel.
Therefore, the TV may not display small text properly.
If you connect this unit to your PC, the compressed
image is displayed in S-XGA mode, therefore the picture
quality may deteriorate and characters may not be read.
Notes:
Some PC models cannot be connected to this TV.
There is no need to use an adapter for computers with
DOS/ V compatible mini D-sub 15 pin terminal.
A bar may appear in the upper, lower, right or left side
of the screen, or parts of the picture may be obscured
depending on some signals. This is not the malfunction.
If the edges of the picture are stretched, readjust the
picture position adjustments in the PC of PICTURE
menu.

Table of Contents

Related product manuals