42
Reference section
Cannot lock signal by using Manual Scan
• Check the frequency that you have entered
is exactly the Middle frequency of the wanted
channel.
• Refer to the solutions for “Poor picture”.
No Teletext, no Subtitle
• Make sure the channel that you are watching
carries Teletext/Subtitle information from .
Cannot receive channels after moving the TV
between cities (e.g. from Melbourne to Sydney)
• Refer to page 17 to reset data.
Weak signal appears on one channel but not the
other, but these channels have the same logical
number
• Please make sure that you do not keep duplicate
channels (i.e. channels with the same logical
channel number but different physical numbers,
see page 16). If you do, please delete the
duplicate ones and keep only one channel with
the best signal strength.
Programme Timer and Alarm do not operate properly.
• Check the antenna connections.
• Weak signal may cause inaccurate time
information.
To Next Page
Loading...
