22
Using the TV’s features
2 Press V or U to select No Signal Power Down
and press Q.
3 Press V or U to select the item you want to
change and press Y or Z to select On or O .
Notes:
• Default setting is all On.
• A warning message will appear 1 minute before
turning o .
Viewing the Software Licences
The licences for the software used in this TV are
available for viewing on screen.
1 From the SETUP menu, press V or U to select
Software Licences.
2 Press Q.
A screen will appear displaying all of the
licencing information required for the TV’s
software.
Con rming software version
1 From the SETUP menu, press V or U to select
System Information.
2 Press Q to display the software version.
System Information
TOSHIBA
2012
Xxx XX 2012 - XX.X.XX.X
MBOOT Version : XXXXXXXX
MFC Version : XXXXXX
Note:
The software version displayed is just for the
illustration.
Resetting the TV
Reset TV will reset all TV settings, including stored
channels, to their original factory values.
1 From the SETUP menu, press V or U to select
Reset TV.
Auto Tuning
Location
Quick Setup
Software Licences
Manual Tuning
System Information
Reset TV
Home
Auto Tuning
Location
Quick Setup
Software Upgrade
Manual Tuning
Home
SETUP
2 Press Q to select.
Activating the 4:3 Stretch
When 4:3 stretch is activated, this function will
switch 4:3 format programmes into a full screen
picture.
1 From the Display Settings menu, press V or U
to select 4:3 Stretch.
2 Press Y or Z to select On or O .
Note:
This feature is not available when Auto Format is set
to O .
Panel Lock
Panel Lock disables the buttons on the TV. All
buttons on the remote control can still be used.
1 From the PREFERENCES menu, press V or U to
select Panel Lock.
2 Press Y or Z to select On or O .
Note:
When Panel Lock is On, a reminder will appear when
the keys on the TV are touched. If the standby key is
touched, the TV will switch o and can only be brought
out of standby by using the remote control.
Setting the Automatic Power Down
The TV will automatically turn itself o (standby)
after approximately 4 hours, if you do not operate
the control buttons on the remote control or on the
TV control panel.
1 From the PREFERENCES menu, press V or U
until Energy Saving Settings is selected, and
then press Q.
2 Press V or U to select Automatic Power
Down, press Y or Z to select On or O , and
then press EXIT.
Note:
1 minute before switching to standby, a warning
message will appear.
Setting No Signal Power Down
The TV will automatically turn itself o after 15
minutes when no signal is detected. You can change
the setting to O for the following purposes:
• Low signal strength of analog channel (no signal
detection).
• Only Audio L/R is connected to an external
input in order to listen to music through the TV
speakers.
1 From the Energy Saving Settings menu, press
Q.
To Next Page
Loading...
