14
Introduction / Getting started
Programming channels into the TV’s channel
memory
• First, use the Auto Tuning function to preset all
the active channels in your area automatically.
Then, arrange the preset channels with the
Manual Tuning function so that you can tune into
only desired channels.
• Use the Manual Tuning operation if desired
channels cannot be preset with the Auto Tuning
or if you would like to preset channels to speci c
position numbers one by one.
Auto Tuning
1 From the SETUP menu, press V or U to select
Auto Tuning.
Menu Language
Auto Tuning
Location
Quick Setup
Antenna
Software Licences
Software Upgrade
Manual Tuning
System Information
English
Home
SETUP
2 Press Q to display the Auto Signal Booster
menu (- page 11), press Y or Z to select Ye s
or No.
3 Press Q to display the Auto Tuning menu.
Auto Tuning
Previous settings will be lost! Press EXIT for no
change.
Start Scan
4 Press Q to start the automatic search.
The search will begin for all available stations.
Auto Tuning
Progress
Found
1%
5 When the automatic search is completed, the
TV will automatically return to 1 position.
Manual Tuning
1 From the SETUP menu, press V or U to select
Manual Tuning.
2 Press Q to display the Manual Tuning menu.
Press V or U to select the programme position
you want to arrange.
Pos.
Label
Manual Tuning
1
2
3
4
6
7
8
5
Channel
C-02
C-04
C-05
C-07
C-12
S-17
S-19
C-09
3 Press Q to display the breakdown menu.
Press Y or Z to select an item, then press V or
U to select the item as shown below.
Manual Tuning
1 B/G A C 20On
Position
ACE FG J
H
IDB
A. Position selection
B. System (Sound) (- page 56)
C. Colour System (- page 56)
A : Automatic (factory set), P : PAL,
S : SECAM, N4 : NTSC 4.43 (MHz),
N3 : NTSC 3.58 (MHz)
If the colour of a certain channel is
abnormal, the automatic colour system
selection (A) may have malfunctioned, or
sound system selection is wrong. In such a
case, select another colour and/or sound
system (- page 57).
D. Position skip selection
Press V or U to turn the position skip
option on “8” or o “(”.
The position will then be skipped when you
select channels with PU or Pu.
The “8” mark will appear when you use the
Number button on the remote control.
E. Signal Class selection (- page 55)
Press V or U to select C or S.
C: 1 ch - 12 ch, 21 ch - 70 ch
S: 1 ch - 41 ch, 51 ch - 55 ch
F. Channel selection
Press V or U until your desired channel is
displayed (- page 55).
G. Search operation
Press U to search up the band or V to
search down the band.
Press V or U repeatedly until your desired
signal is displayed.
NEVER PRESS ANY OTHER BUTTONS WHILE
THE SET IS TUNING.
To Next Page
Loading...
