29
Setting the 3D Timer Lock
When the 3D Timer Lock feature is set to On, neither
the PIN input window nor the 3D start message will
be shown while the 3D Enable timer is active, even
if a switch to 3D Mode occurs. This helps to avoid
having to enter the 3D Lock PIN and view the 3D
start message every time when switching to 3D.
1 From the 3D Safety Settings menu, press Q
and Enter your 4-digit 3D PIN code.
2 Press V or U to select 3D Timer Lock and press
Y or Z to select On or O .
Note:
The PIN input window appears when “continue” is
selected in the reminder dialogue for Enable 3D Timer,
even if 3D Timer Lock is activated.
Setting Enable 3D Timer
This feature helps to remind you not to watch 3D
video for extended periods of time. Once a set
period of time has passed, a dialogue will be shown
asking you if you wish to continue viewing in 3D or
not.
1 From the 3D Safety Settings menu, press Q
and Enter your 4-digit 3D PIN code.
2 Press V or U to select Enable 3D Timer and
press Y or Z to select O , 30, 60, 90 or 120
minutes.
Displaying the 3D Important Info
This feature helps to remind you not to watch 3D
video for extended periods of time. Once a set
period of time has passed, a dialogue will be shown
asking you if you wish to continue viewing in 3D or
not.
1 From the 3D Setup menu, press V or U to
select 3D Important Info.
2 Press Q.
Adjusting 2D to 3D Depth
You can adjust an e ect quantity to change the 2D
mode for the 3D mode.
From the Menu:
1 From the PREFERENCES menu, press V or U to
select 3D Setup and press Q.
2 Press V or U to select 2D to 3D Depth and
press Q.
3 Press Y or Z to select 1, 2, 3, 4, or 5.
From the Quick Menu:
1 Press QUICK. Select 3D Settings and press Q.
2 Press V or U to select 2D to 3D Depth and
press Q.
3 Press Y or Z to select 1, 2, 3, 4, or 5.
Switching left and right images
The left and right eye shutter timing of the glasses
can be swapped. If 3D images look blurred, switch
the left and right sides of the 3D image.
1 Press QUICK . Select 3D Settings and press Q.
2 Press V or U to select Left and Right Image
and press Y or Z to select Swapped or
Normal.
Selecting the video input source to view
1 Press on the remote control until the
video input mode list appears on the screen,
then press V, U or
to select appropriate
input source (or touch p / o and U or u on
the TV left side panel to select required input
source directly).
TV
Inputs
VIDEO1
VIDEO2
HDMI 1
HDMI 2
HDMI 3
HDMI 4
PC
2 Press Q.
VIDEO1 (o (1), COMPONENT/VIDEO INPUT,
standard or component video input) ,
VIDEO2 (o (2), standard video input),
HDMI1, HDMI2, HDMI3, HDMI4 (HDMI input),
PC (o RGB/PC, PC input)
Using the TV’s features
To Next Page
Loading...
