39
Wireless LAN and your Health
Wireless LAN products, like other radio devices, emit
radio frequency electromagnetic energy. The level
of energy emitted by Wireless LAN devices, however,
is far less than the electromagnetic energy emitted
by wireless devices such as mobile phones.
Because Wireless LAN products operate within the
guidelines found in radio frequency safety standards
and recommendations, TOSHIBA believes Wireless
LAN is safe for use by consumers. These standards
and recommendations re ect the consensus of the
scienti c community and result from deliberations
of panels and committees of scientists who
continually review and interpret the extensive
research literature.
In some situations or environments, the use of
Wireless LAN may be restricted by the proprietor
of the building or responsible representatives of
the organization. Such restrictions may apply in
environments where the risk of interference to
other devices or services is perceived or identi ed
as harmful.
If you are uncertain of the policy that applies to the
use of wireless devices in a speci c organization
or environment, you are encouraged to ask for
authorization to use the Wireless LAN device prior to
turning on the equipment.
How to use this Dual Band Wireless LAN Adaptor
• If this device is going to be operated in the
frequency range of 5.15 GHz to 5.35 GHz, it is
restricted to indoor use.
Setting up the Network
To select the Network Type
(except for 40VL20EE/E5/V5 and 46VL20EE/E5/V5
models)
1 From the PREFERENCES menu, press V or U to
select Network Setup and press Q.
2 Press V or U to select Network Type, and then
press Y or Zto select Wired or Wireless.
deriWepyT krowteN
Network Connection Test
Advanced Network Setup
Network PIN Setup
Network Lock
Network Setup
Wireless Setup
Off
Note:
If the Dual Band WLAN Adaptor is not connected,
Wireless cannot be selected.
3 If you selected Wired, see “Advanced Network
Setup” (- page 41).
Wireless Setup
(except for 40VL20EE/E5/V5 and 46VL20EE/E5/V5
models)
Notes:
• This feature is grayed out when the Dual Band WLAN
Adaptor is not connected or Network Type is set to
Wired.
• When you insert or remove the wireless LAN adaptor,
you must turn o your TV and unplug the power
cord, and then plug and turn on again.
• Continued connection of AP (Access Point) is not
guaranteed. The connection may be disconnected
while watching TV.
• Do not remove the Dual Band WLAN Adaptor
when Network Type is set to Wireless or wireless
communication is active.
There are 2 methods for Wireless Setup:
Assisted setup by using the Wireless Routers
noti cation information.
Network name, Authentication and Encryption
are decided based on information sent from the
Wireless router. Security key to be set manually.
Manual setup
Network name, Authentication, Encryption and
Security Key all to be inputted manually.
Assisted Setup
1 From the PREFERENCES menu, select Network
Setup and press Q.
2 Press V or U to select Wireless Setup and
press Q.
3 Press V or U to select Assisted Setup and
press Q.
Wireless Setup
Assisted Setup
Manual Setup
4 Press V or U to select the desired AP and press
Q.
Note:
Check the MAC address on the label of the AP or in
the manual, and select your AP.
5 Press V or U to select Security Key and press
Q.
The Software Keyboard window will appear.
Connecting your TV
To Next Page
Loading...
